Get the correct calibrated dosage of your hemp each and every time.
No more side effects from too much hemp.
ABOUT THE MICRO DOSE INHALER (MDI)
The Unique CannaKit Inhaler
Designed by Dr. Gregory Smith, as a kit to help you manage your daily doses of hemp throughout the day. It was designed for those 40% of hemp patients whom prefer to smoke their hemp. They want the convenience and speed of smoked hemp, but don’t want problems getting too much hemp or wasting unused material using traditional methods of smoking hemp.
HOW TO USE THE CANNAKIT
RECOMMENDED DOSING TABLE
Estimated Numbers of Milligrams (mg) of Absorbed Cannabinoid Micro-Dose Inhaler (MDI)
|% Cannabinoid in Hemp||One (25mg) Inhalation||Two (50mg) Inhalations|
THE CANNAKIT KEEPS IT SIMPLE
HOW TO USE OUR PRODUCT
How to use Canna Kit MDI
When your MDI is packed to the edge with ground bud it contains 50mg of hemp. When you burn hemp in the MDI about 50% is incinerated and not used, so that only 50% is usable as inhaled oil. When hemp is heated to a certain temperature the inactive THCa and CBDa are turned into the active ingredients THC and CBD. Your MDI is not a cigarette. Each inhalation requires that you light it with a match or lighter. After you take you the single inhalation, wait for about 10 minutes until you get the ‘peak level’ from the inhalation to determine if you need to take a second inhalation.
You will need to purchase a grinder separately. They are available at dispensaries and online at www.CannaKit.com. The dispensary staff member where you purchase your hemp can tell you how to correctly grind hemp bud. It is this ground hemp that is packed into the MDI.
When you use the MDI, you take one long deep inhalation and hold it briefly, only for about 2 seconds. Maximum absorption of the vaporized oils occurs at 2 seconds, so there is no need to hold inhalation for longer than this. If you have a question about how to inhale correctly ask the staff member at the dispensary.
Approximately 40% of the millions of patients that use hemp prefer to smoke it. If, after discussion with your medical professional, you have decided to inhale your hemp medication as smoke then the Canna Kit® micro-dose inhaler (MDI) may be right for you. The expertly designed, and quality manufactured MDI allows you to quickly and easily pack 50mg of hemp plant material into the receiving end. This small amount of ground hemp allows you to control your dose down to fractions of a milligram per dose. No other means of smoking hemp allows for this kind of fine adjustment.
Inhaling hemp is entirely different from any other medication that you may be taking. Because you want to prevent the chance of side-effects, it is always recommended to start low and go slow. This means to start at about half of the recommended dose, inhale once, then wait for 10-15 minutes, before taking the second inhalation. It is also prudent to take your first doses when side-effects, such as euphoria, balance issues, paranoia, or anxiety, if they do occur, won’t create an issue.
After trying out the MDI for inhaling several times over several days, if you feel comfortable and are not having side-effects, you can take your inhalations right after each other.
Because bud is a plant that is grown under a variety of conditions, the potency of the bud you buy will vary each time you buy a new batch. So it is important each time you purchase a new supply of bud to “start low, and go slow” because the new batch may be much more potent than the last batch. Or, it may not be as potent. By starting low and going slow you will soon be able to get the correct dose again with each new batch.
The same holds true when you change your dose. If you doctor advises you to from 3mg of THC to 5mg of THC, this is a 60% increase in the amount of medication. It is important to gradually move up to the new dose so that you don’t get unpleasant or hazardous side-effects.
Incinerated oils and by-products will accumulate in the MDI due to repeated use. There is a small metal tool that is provided in the Canna Kit® that is used to clean the MDI. It is best to do this at least once a week to keep an effective air flow through the MDI.